Product description:
Hicem Stanadard is an adhesive dry-set mortar for typical tile setting or repairs. The bonding agents and other additives of Hicem Standard meets all the requirements for a strong, permanent, moisture resistent bond. It is highly recommended for a wide variety of interior or exterior design, and all wall and floor tile installation in homes or commercial bussiness.

How to apply
1. Working surface should be clean and free of contaminants.
2. Mix Hicem Standard into clean ,fresh water with three (3) parts Hicem Standard to one (1) part water stir briskly about 5 mins or until well blended. Let stand for 3-5 mins. Do not add more water. Mixture will be viable for approximately 60 mins.
3. Apply Hicem Standard to the working surface in a smooth layer 6-8 mm. thick, then comb the adhesive with a notched trowel for a ribbed effect. Apply the tile firmly with a slight twist to insure proper adhesion.
Note: Excessively warm or dry surfaces can be dampened slightly before adhesive application.
Note: On uneven surfaces, Hicem Standard may be applied in various thickness from 5 - 10 mm. to allow a smooth and level tile application. A thickness greater than 10 mm. is not recommended.
4. Avoid spread excessive adhesive over a large surface which could dry before tile application.

Technical Data
open time > 20 mins
Setting time 20-30 mins
Water retention 84.70%
Compressive Strength 285 kgf/cm2
Bond Strength 143 Kgf/cm2
Shear Adhesion Strength 11.36 kgf/cm2
Flexural Strength 100.7 Kgf/cm2
Length change 0.114 %
Verticle Sliding 0.04 mm.

Quantity 20 kg/bag
Using quantity 7-10 square meters/20 kg (bag)
Storage Storage in dry room increase shelf life similar to cement.